|
|
6-2-10-snyatie-i-ustanovka-toplivnogo-baka.html
6.2.10. Removal and installation of a fuel tank
|
- Empty a fuel tank.
- Press топливопровод and to weaken a fastening collar топливопровода to the fuel pump. Separate sockets of electroconducting of both sensors of a stock of fuel (see. Head Suspension bracket and steering).
- Remove the driveshaft in collecting (see. Head Kardanny and power shafts, reducer, differential and stupichny assemblies).
|
- Unhook a cable and give fixture of the directing channel.
|
|
- Remove the left and right protective casings.
|
|
- Remove bringing (1) and drain (2) pipelines.
|
|
At installation replace fuel hoses together with fastening collars. |
|
- Give fixture of tapes of fastening of a fuel tank.
|
|
Pay attention to the rezinometallichesky hinge with a prostavochny washer, and also on the provision of laying in a flat hook of a tape. The wide corbel on a washer indicates a bolt head. |
- Prop up a fuel tank.
|
- Turn out bolts with left and on the right side.
|
|
Pay attention to the rezinometallichesky hinge with a prostavochny washer - the wide corbel on it indicates a bolt head. |
- Slightly lower a fuel tank and cast away outside so that became available топливопроводы on its top party. To disconnect топливопроводы on the left top side of a fuel tank.
|
- Disconnect EVAP hose on the top right side of a fuel tank.
|
- Lower a fuel tank and remove it movement down.
- Installation is made upside-down. Check rubber laying on the back party of a tank and in a groove in the body basis.
|
|
|
|
|