|
|
4-6-10-snyatie-i-ustanovka-vpusknogo-truboprovoda.html
4.6.10. Removal and installation of the inlet pipeline
|
After removal of a collector it is necessary to close at once inlet channels in a head of the block of cylinders. |
|
If the established hoses of naduvochny air are not fat-free or damp, it can lead to turbokompressor failure. |
|
- Disconnect a negative wire from the storage battery.
- Remove forward section of the top cover of the engine and raise the central part of the top cover.
|
- Uncover a conclusion of the positive plug of the storage battery in an impellent compartment. Give a nut and movement up remove a conclusion of the positive plug.
|
|
- Remove from the inlet pipeline sound-proof casings.
|
|
- Turn out screws (1) and remove profile consolidation (2).
|
|
- Disconnect the socket of the sensor of pressure of pressurization.
|
|
- Weaken a collar (1), disconnect a hose (2) and remove a collar (3) pipelines of EGR system.
|
|
- Turn out screws (1) and give nuts (2). Disconnect the vacuum pipeline (3) from the EGR valve. Raise the inlet pipeline a little and release the vacuum pipeline (from the vacuum pump) from clips on the lower part of the inlet pipeline.
|
|
Watch the provision of both clips of fastening of a sound-proof casing on a collector. After pipeline removal at once close inlet to prevent their pollution. |
|
- Replace sealing rings (1 and 2).
|
- Installation is made upside-down. Interfaced surfaces should be dry and fat-free.
|
|
|
|
|