Replacement of a belt of a drive of the To/in compressor of the M73 engine is made similar to replacement of a belt of a drive of the To/in compressor of the M60 engine (see. Section Removal and installation of belts of a drive of auxiliary units). Only procedure of replacement of a belt of a drive of the generator below is given.
If further use of a removed belt is supposed, note the direction of its movement.
PERFORMANCE ORDER
Remember the scheme of laying of a belt on pulleys.
Lay a driving belt on pulleys and rollers and make sure of correctness of its situation.
At installation of already used belt observe the former direction of its movement.
Move an adjusting plate of a natyazhitel of a belt for a shestigrannik (5) against the stop and tighten at first nuts 3 and 4, and then – nuts 1 and 2.