BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.4.1. Removal and installation of a cover of a head of cylinders
4.4.2. Removal and installation of a head of cylinders, adjustment of phases GRM
4.4.3. Removal and installation of the top section of the pallet of a case
4.4.4. Removal and installation of the pallet of a case
4.4.5. Removal and installation of covers of a chain of GRM
4.4.6. Replacement of epiploons of a cranked shaft
4.4.7. Removal and flywheel installation
4.4.8. Removal and installation of belts of a drive of auxiliary units
4.4.9. Removal and installation of a damper of krutilny fluctuations and its nave
4.4.10. Removal and installation of the oil pump
4.4.11. Removal and installation of the inlet pipeline
4.4.12. Removal and installation of final collectors
4.4.13. Removal and engine installation
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

4-4-6-zamena-salnikov-kolenchatogo-vala.html

4.4.6. Replacement of epiploons of a cranked shaft

For removal and installation of epiploons it is recommended to use special adaptations. For access to the forward epiploon established in the bottom cover of a chain of GRM, remove a damper of krutilny fluctuations. Procedure of ensuring access to a back epiploon below is described.


 PERFORMANCE ORDER

  1. Remove RKPP together with coupling or AT (see. Head Manual box of gear shifting and coupling or Automatic transmission).
  2. Lower impellent oil (see. Head of Control and routine maintenance of the car).
  3. Remove a flywheel (see. Section Removal and flywheel installation).
  1. Turn out fixing bolts.
  1. Turn out bolts of fastening of a cover of a back epiploon of a cranked shaft. Separate case laying from a cover of a back epiploon and uncover.

The cover of a back epiploon is delivered complete with an epiploon. If necessary it is possible to take and establish an epiploon in a cover by means of the special adaptation

  1. Replace laying. On joints with a case put Hylomar SQ32 Spezial hermetic.
  1. Establish on a cranked shaft the adaptation No. 11 2 390. Grease with impellent oil working edges of an epiploon and place on a regular place an epiploon cover then carefully remove the adaptation No. 11 2 390.
  1. If openings under bolts of fastening of a cover of a back epiploon are closed, use bolts with a six-sided head, having paid attention to their length. Otherwise use bolts with a head under a prutkovy key, thus use new washers.

«previous page
4.4.5. Removal and installation of covers of a chain of GRM		 following page»
4.4.7. Removal and flywheel installation