|
|
4-4-3-snyatie-i-ustanovka-verkhnejj-sekcii-poddona-kartera.html
4.4.3. Removal and installation of the top section of the pallet of a case
|
For removal of an oil case it is required to lower a beam of the forward bridge. |
|
- Disconnect a negative wire from the storage battery.
|
- Fix a cowl in extreme top situation. For this purpose disconnect from it a damper, completely open a cowl and fix it bolts at the left and on the right.
|
- Remove the top casing of the engine.
- Remove the top part of the case of an air purifier together with the MAF sensor (see. The section Replacement of a filtering element of an air purifier of Head of Control and routine maintenance of the car).
|
- Remove directing щупа level of impellent oil from the right cover of a chain of GRM.
|
|
- Give the top nuts of the left and right pillows of support of the engine.
|
- Hang out the engine by means of the special adaptation, using elevating eyes of the engine.
- Remove the case pallet (see. Section Removal and installation of the pallet of a case).
- Weaken a tension of a belt of a drive of the To/in compressor and remove a tension level of a natyazhitel from an oil case.
|
- Remove the pump GUR, without disconnecting pipelines.
|
|
If necessary turn out from the top section of the pallet of a case an adjusting pin, take aside and adhere the pump. |
- Disconnect a protective casing of plusovy contact in an impellent compartment from an oil case and from the right support of the engine. Disconnect a positive wire of the storage battery from a starter and from the left basic arm.
- Disconnect directing tube щупа level of impellent oil from a crater.
|
- Disconnect from the case pallet a returnable tube.
|
- Disconnect a steering shaft from the steering mechanism (see. Head Suspension bracket and steering).
- Unclench a bracket of fastening of the hydraulic pipeline to a beam of the forward bridge and prop up a beam by means of the special adaptation.
- Disconnect a beam of the forward bridge from a support of the engine and lower approximately on 60 mm (see. Head Suspension bracket and steering).
|
- Turn out bolts of fastening of the top section of the pallet of a case from transmission.
|
- If necessary unclench brackets of fastening of pipelines from an oil radiator to a case. Turn out the remained bolts of fastening of the top section of the pallet of a case and remove it, shifting forward.
- Installation is made upside-down. Pay attention to the next moments:
- If necessary replace sealing rings directing щупа level of impellent oil;
- Clear interfaced surfaces of the remains of sealing materials and grease these surfaces with Hylomar SQ 32 hermetic M;
- Replace laying of the top section of the pallet of a case;
- Finally to tighten bolts from transmission follows only after a tightening of bolts from the engine.
|
|
|
|
|