4-4-11-snyatie-i-ustanovka-vpusknogo-truboprovoda.html
4.4.11. Removal and installation of the inlet pipeline
|
- Disconnect a negative wire from the storage battery.
- Disconnect from the inlet pipeline electroconducting of the engine and take her aside.
- Disconnect from the fuel distributive highway hoses of a supply and fuel return, remembering an order of their connection and a place of their fastening by collars.
|
- Disconnect the union of the vacuum line from the amplifier of brakes.
|
|
- Remove a clip and extend PCV tube. Check a condition of a sealing ring of a tube and if necessary replace it.
|
|
- Give nuts, take prostavochny plugs and remove the inlet pipeline in the direction up.
|
|
- If necessary uncover (1) with the return valve.
|
|
- Check a condition of laying and a sealing ring of the valve. If necessary replace them.
|
- Center the inlet pipeline on two prostavochny plugs established on its left and right parties. Then establish the remained plugs and tighten nuts with demanded effort.
- Further installation is made upside-down.
|
|
|
|