3-23-proverka-tolshhiny-vedomogo-diska-scepleniya.html
3.23. Check of thickness of a conducted disk of coupling
|
On models with the M62 engine from 09.1996 g вып. check of thickness of a conducted disk of coupling is not required. |
|
- Remove the executive cylinder of a hydraulic actuator of coupling, without disconnecting from it the pressure head pipeline (see. Head Manual box of gear shifting and coupling).
|
- Establish the special adaptation 21 2 080 so that the scale corresponding to the RKPP this type, was visible from below. The scale of B is intended for 4-cylinder engines without a 2-mass flywheel with RKPP S5D 200G; scale D of G is intended for RKPP S6S 420G and S6S 560G; a scale of B C – for 6-цилиндровыз and 4-cylinder engines with RKPP S5D 200G/250G/260Z/310Z/320Z.
|
- Press a pin of the measuring adaptation to a fork of switching off of coupling and take readings of wear of a disk.
|
- If the red site (2) scales is thus visible, it is necessary to replace a conducted disk of coupling. The site (1) indicates normal wear of a disk.
|
|
|
|
|