|
|
14-4-2-snyatie-i-ustanovka-blokov-upravleniya.html
14.4.2. Removal and installation of control unitsDoor control unit
|
- Remove door furnish (see. Head Body).
|
- Separate sockets, turn out screws and remove the door control unit.
|
|
|
Control unit sun-protection shtorka of back glass
|
- Remove partially a back of back sitting or the lateral panel of a back of the right back seat (see. Head Body).
|
- Separate the socket (1), turn out the screw (2) and take out the control unit.
|
|
|
DU control unit
|
- Remove partially a back of back sitting or the lateral panel of a back of the left back seat (see. Head Body).
|
- Separate the socket (1) and an antenna cable (2). Give a nut (3) and remove the DU control unit.
|
|
|
SRS control unit
|
- Disconnect a negative wire from the storage battery.
|
- Wring out from each other a ventilating lattice and a level or the control unit a heater a little. Release from the top holders and take out a level or the control unit a heater. Displace approximately on 30 ÷ 40 cm down and remove a ventilating lattice.
|
|
At installation get the central part of a ventilating lattice and insert up to the end movement up then establish a slip or the control panel a heater. |
|
- Separate sockets and remove a slip or the control panel a heater.
|
|
- Give nuts and raise the SRS control unit.
|
|
Before installation of the SRS control unit to track that the wire on weight was put on an adjusting hairpin (1). |
|
- Separate the socket and remove the SRS control unit.
|
|
|
|
|
|