|
|
13-2-3-snyatie-i-ustanovka-otdelki-i-zvukoizolyacii-zadnejj-dveri.html
13.2.3. Removal and installation of furnish and sound insulation of a back doorFurnish
|
|
- Remove a cap (1), liberate a clamp and remove the button (2) movement up.
|
|
- At a complete set sun-protection shtorka on lateral glasses unhook a shtorka (1) above and remove movement back and up (2).
|
|
- At a complete set sun-protection shtorka on lateral glasses turn out the screw.
|
|
- Remove a lamp of illumination of a foot well and the window regulator switch. Separate both sockets. Remove a cap (1) and turn out the screw.
|
|
- Liberate the panel of furnish of a door from clamps on all its perimeter, extend the furnish panel from clips movement up and push the internal handle of a drive of the lock of a door via the furnish panel.
|
- Remove internal bottom consolidation of glass of a door by movement up.
- Installation is made upside-down. Pay attention to the next moments:
- Replace the damaged clamps.
- At a complete set sun-protection shtorka on lateral glasses before installation of the panel of furnish of a door delay a curtain up and check serviceability of its functioning.
|
- Check distance (A = 14.5 ± 1 mm) between a cap (1) and directing (2). If necessary remove the button and adjust position of the plug (3).
|
|
|
Sound insulation
|
- Remove facing of a back door.
- On models with a lateral safety cushion remove it.
|
- Separate the socket (1), turn out screws (2) and remove loudspeaker knot. Remove the handle of a drive of the lock of a back door.
|
|
- Disconnect the central light source (1) from an arm (2), separate the socket (3) and disconnect an optical fiber (4) from the central light source.
|
|
The radius of a bend of optical fiber should not be less than 20 mm. |
|
- Turn out screws (1) and remove an arm of the central light source (2).
|
|
- Unclench collars (1) on a plait of electroconducting (2) and on a cable (3), separate sockets (4).
|
|
- Take clamps (1 and 2), turn out the screw (3) and unhook a cable (4).
|
|
- In whole or in part separate the sealing roller (1) and remove or unbend sound insulation (2).
|
- Clear interfaced surfaces and lay a butyl cord in diameter of 6 mm on sound insulation and a door, heat up it the technical hair dryer, impose sound insulation and strongly press it on all perimeter with effort of 30 N/cm2.
- Further installation is made upside-down.
|
|
|
|
|