13-2-12-snyatie-i-ustanovka-kryshki-verkhnego-lyuka.html
13.2.12. Removal and installation of a cover of the top hatch
|
Do not apply force when moving the movable panel of a roof. |
Removal
|
|
- Open a cover on 250 mm, verify bolts (2) so that the opening became free, and close a cover.
|
- Shortly press a key of opening of the top hatch and again stop it. Thus the back part of a cover should fall by 2 ÷ 4 mm.
- Slowly move the movable panel of a ceiling up to the end back and close a cover.
|
After that it is not allowed to make active a cover in the Open direction (danger of damage of the mechanism). |
|
- Give nuts and uncover the top hatch movement up and back.
|
|
At installation replace nuts or process old nuts Loctite 270 structure. |
|
|
Installation
|
|
- As appropriate hook in front for a sled (2) left and right adjusting levers (1).
|
- Palm wring out a forward part of a cover with left and on the right side from below up. Thus the cover should not rise. Adjusting levers along the edges of a cover should enter into gearing as appropriate.
|
- Wring out an elevating and movable cover of the hatch forward and tighten nuts (2) by hand.
|
- Lower a back part of a cover of the top hatch on mm size 2 ÷ 4.
- Slowly move the movable panel of a ceiling up to the end forward.
- Open a cover of the top hatch approximately on 250 mm, carefully wring out it up, screw fixing bolts (2 on an illustration) from the left and right side and tighten them.
|
|
|
|