|
|
13-1-6-snyatie-i-ustanovka-zadnego-bampera-i-ego-komponentov.html
13.1.6. Removal and installation of a rear bumper and its components
Components of assembly of a front bumper
|
- Remove the central overlay of a rear bumper, from жав it from clamps a plastic wedge.
|
- Turn out a bolt of fastening and rasporny bolts (1) from the left and right side and remove lateral aprons (2) wheel arches.
|
|
- Turn out bolts from the left and right side by means of the special adaptation No. 51 1 080.
|
|
- Unclench clamps and disconnect a bumper from directing from below.
|
|
- Delay a bumper a little back and take a bolt with a cylindrical head through an opening (2) by means of a magnetic core movement sideways and up.
|
|
If to take a bolt with a cylindrical head through an opening (2) it is not obviously possible, if necessary, it is possible to make (1) small cut in an invisible place of a crossing point. |
- Pull a bumper on itself and remove it.
- At replacement of a bumper rearrange from an old bumper on new decorative elements and a basic beam.
|
Central and lateral slips it is possible to replace without bumper removal, – wring out them from clamps by means of a plastic wedge. |
- Installation is made upside-down.
|
|
|
|
|