|
|
12-5-6-snyatie-i-ustanovka-zamka-zazhiganiya-i-blokirovki-rulevogo-kolesa.html
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
|
- Remove the top bearing of a steering shaft and the top casing of a steering column (see. Section Removal and installation of casings of a steering column).
- Remove the ring aerial of EWS system.
- Remove arms of podrulevy switches (see. Head Onboard electric equipment).
|
- At the corresponding complete set disconnect draft of Interlock system.
|
|
- Turn out a bolt and remove the holder of a plait of electroconducting. Separate the socket of electroconducting of the lock of ignition.
|
|
- Cut off a head of the disposable screw, remove a plate (1) and the lock (2) shaft of a steering wheel.
|
|
At installation tighten the disposable screw to an obryvaniye it on a neck. |
- Remove the cylinder of the lock and to put the new lock of a shaft of a steering wheel.
|
- Remove a protective varnish, turn out control screws and establish the ignition switch on the new lock of a shaft of a steering wheel.
|
|
At installation paint over heads of secret screws. |
- After installation check functions of the lock of ignition and podrulevy switches.
|
|
|
|
|