|
|
12-3-zadnyaya-podveska.html
12.3. Back suspension bracketRemoval and installation of assembly of a beam of a back suspension bracket
|
- Remove back wheels and the driveshaft (see. Head Kardanny and power shafts, reducer, differential and stupichny assemblies).
- Pump out fuel from the right tank of a fuel tank, disconnect a hose from a jellied mouth of a fuel tank and muffle open openings (see. Head of the Power supply system and production of the fulfilled gases).
- Remove supports of the brake mechanism from both parties and suspend them on a body; remove back wheel sensors of ABS system (see. Head Brake system).
|
- Take out a cable of a drive of the parking brake from a connecting clip and remove from a body the right arm of fastening of a cable.
|
|
- Give a nut and disconnect the lever of the sensor of size of a road gleam. Remove from a beam of a back suspension bracket the valve of adjustment of a road gleam.
|
|
- Turn out bolts of fastening of the shock-absorber to a support of the stupichny bearing.
|
|
At installation the head (1) with лысками the rezinometallichesky hinge should be turned to a bolt head. |
|
- Prop up the back bridge by means of support No. 00 2 030/040 and No. 33 4 220.
|
|
- To turn out the left and right bolts and carefully to lower the back bridge.
|
|
At installation of a hairpin (1) back basic heel should be established parallel to a car axis. |
|
|
|
|
|