|
|
12-2-6-snyatie-i-ustanovka-stupichnogo-podshipnika.html
12.2.6. Removal and installation of the stupichny bearing
|
After dismantling the knot of the stupichny bearing is subject to replacement. |
|
- Remove a brake disk (without disconnecting a brake hose) and the wheel sensor of ABS system (see. Head Brake system).
|
- Remove a screw-driver a nave cap.
|
|
At installation use a new cap. |
|
- To Razkontrita a koronchaty nut also give it, having used, for example, a key No. 31 2 080.
|
|
At installation use a new nut. |
|
- Remove bearing knot by means of the adaptation No. 33 2 116/33 4 201/202/203 and wheel bolts (1).
|
|
- If necessary remove an internal ring of the bearing from the end of a beam of a suspension bracket by means of the special adaptation No. 33 4 402. For this purpose put on the adaptation No. 33 4 406/401 an internal ring of the bearing and compress until the adaptation will be turned hardly.
|
|
- Alternatively for removal of a boot and an internal ring of the bearing it is possible to use the adaptation No. 31 2 100, previously having removed a protective casing.
|
|
- Establish laying (1) on a new boot (2).
|
|
- Establish a protective casing (1) and a new boot (2).
|
|
The opening in a boot should be coaxial to an opening in a rotary fist. Screw against the stop an opravka No. 31 2 110. |
|
- Get new knot of the stupichny bearing and напрессуйте it by means of an opravka No. 31 2 110.
|
- Screw a new koronchaty nut, tighten it with demanded effort and законтрите, tapping on it.
|
At a postukivaniye the nut should be fixed in a flute! |
- Establish a new cap on hermetic.
- Establish the wheel sensor and a brake disk.
|
|
|
|
|