|
|
12-2-4-snyatie-i-ustanovka-rastyazhek-rychagov-i-sharnirov-rastyazhek.html
12.2.4. Removal and installation of extensions of levers and hinges of extensions
|
Installation or replacement of rezinometallichesky hinges of extensions of the right and left levers of a suspension bracket should be made at the same time. |
|
- Remove protection of a case of the engine.
|
- Remove an extension of the lever of a suspension bracket.
|
|
At installation establish a washer (1), use new самоконтрящиеся nuts. |
|
- Give a nut and выпрессуйте a spherical support by means of a stripper No. 31 2 240.
|
|
At installation on landing cones there should not be greasing traces; use new самоконтрящиеся nuts. |
|
- The Rezinometallichesky hinge acts in film and pressed by means of a press and an opravka No. 31 2 261/263.
|
|
At installation on the hinge and in an opening of an extension there should not be greasing traces. |
|
- The label on the hinge should be combined with a label on an extension. At a press fitting the opravka should adjoin to the external plug of the hinge, – the maximum admissible not planeness makes ± 3 °.
|
|
- Watch that the ledge (A) made 12.5 ± 0.2 mm.
|
- Installation is made upside-down.
|
|
|
|
|