10-4-zamena-promezhutochnojj-opory-kardannogo-vala.html
10.4. Replacement of an intermediate support of the driveshaft
|
- Remove the driveshaft (see. Section Removal and installation of the driveshaft and elastic coupling).
|
- Not to break balancing of assembly of the driveshaft, mark with paint its relative positioning of forward and back parts.
|
|
Do not use for this purpose the subjects, capable to damage a shaft surface (for example, a center punch). |
- Turn out a bolt (1) and separate the driveshaft.
|
- Remove a prostavochny washer and a boot.
|
|
- Remove an intermediate support by means of the adaptation No. 00 7 500/33 1 307 and a usual stripper.
|
- Establish against the stop a new intermediate support by means of an opravka No. 24 0 090 or No. 24 1 050 respectively at diameter of an internal opening of a support of 30 or 35 mm.
- Establish a new connecting bolt, having greased it with fixing hermetic. At installation watch, that on a carving there were no greasing traces.
- Combine adjusting labels and tighten a bolt with demanded effort.
|
|
|
|