BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
9.1. General information
9.2. Search of malfunctions
9.3. Removal and AT installation and hydrotransformer
9.4. Removal and installation of the pallet of a case
9.5. Removal and PNP sensor installation
9.6. Removal and installation of the ATF filter and hydraulic block
9.7. Removal and installation Ý/m valves, regulators and sensors
9.8. Replacement of an arm of the mechanism of switching of AT modes
9.9. Adjustment of the balance weight of switching
9.10. Adjustment of the lever of the selector
9.11. Adjustment and check of blocking of the lever of the selector
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


9-8-zamena-kronshtejjna-mekhanizma-pereklyucheniya-rezhimov-at.html

9.8. Replacement of an arm of the mechanism of switching of AT modes

 PERFORMANCE ORDER

  1. Execute the actions described in paragraphs from 4 on 6 Section Removal and AT installation and the hydrotransformer.
  2. Remove the handle of the lever of the selector, having pulled it with force up.
  3. Separate from the central console the decorative panel of the lever of the AT selector raise it.
  1. Separate sockets.
  1. Turn out bolts of fastening and remove the PNP sensor.
  1. Turn out bolts of fastening and take the selector lever together with a basic arm, having pulled it up, and then on itself.
  1. Installation is made upside-down. The pin of the switch should enter into dredging at the selector lever. The rim of rubber consolidation should adjoin to a mat of the central tunnel.


«previous page
9.7. Removal and installation Ý/m valves, regulators and sensors
following page»
9.9. Adjustment of the balance weight of switching









http://b3-b4.ru/