BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
9.1. General information
9.2. Search of malfunctions
9.3. Removal and AT installation and hydrotransformer
9.4. Removal and installation of the pallet of a case
9.5. Removal and PNP sensor installation
9.6. Removal and installation of the ATF filter and hydraulic block
9.7. Removal and installation Ý/m valves, regulators and sensors
9.8. Replacement of an arm of the mechanism of switching of AT modes
9.9. Adjustment of the balance weight of switching
9.10. Adjustment of the lever of the selector
9.11. Adjustment and check of blocking of the lever of the selector
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


9-7-snyatie-i-ustanovka-eh-m-klapanov-regulyatorov-i-datchikov.html

9.7. Removal and installation Ý/m valves, regulators and sensors

 PERFORMANCE ORDER

  1. Arrangement Ý/m valves, regulators and sensors.
1-5 — Ø/m valves
6 — Ø/m the valve of the coupling of blocking of the hydrotransformer
7 — a pressure Regulator
8 — the Pulse sensor (frequencies of rotation of the turbine of the hydrotransformer, average)
9 — the Pulse sensor (frequency of rotation of a target shaft)
10 — the Temperature-sensitive element
  1. Remove the hydraulic control unit (see. Section Removal and installation of the ATF filter and hydraulic block).
  1. Separate No. No. 1-5 sockets from Ý/m valves.

Do not pull for wires.


  1. Turn out bolts of No. No. 6-9 and remove an arm (10).

At installation the convex party of an arm should be turned by camber to Ý/m to valves

  1. Take out Ý/m No. No. 1-5 valves.
  1. Remove Ý/m the valve (6), separate sockets (1 and 2) and turn out a bolt (3).
  1. Remove an arm (4) and take out Ý/m the valve No. 6.

At installation the concave party of an arm (4) should be turned to the block of valves. As a distinctive sign Ý/m the valve No. 6 has the white case regarding the socket.




  1. For removal of sensors separate the corresponding socket (1) and turn out bolts (2 and 3).


«previous page
9.6. Removal and installation of the ATF filter and hydraulic block
following page»
9.8. Replacement of an arm of the mechanism of switching of AT modes









http://b3-b4.ru/