BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
9.1. General information
9.2. Search of malfunctions
9.3. Removal and AT installation and hydrotransformer
9.4. Removal and installation of the pallet of a case
9.5. Removal and PNP sensor installation
9.6. Removal and installation of the ATF filter and hydraulic block
9.7. Removal and installation Ý/m valves, regulators and sensors
9.8. Replacement of an arm of the mechanism of switching of AT modes
9.9. Adjustment of the balance weight of switching
9.10. Adjustment of the lever of the selector
9.11. Adjustment and check of blocking of the lever of the selector
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


9-6-snyatie-i-ustanovka-filtra-atf-i-gidravlicheskogo-bloka.html

9.6. Removal and installation of the ATF filter and hydraulic block

Below the description on AT A5S 310Z example is provided.


 PERFORMANCE ORDER

  1. Remove the pallet of a case of AT (see. Section Removal and installation of the pallet of a case).
  1. Turn out bolts and remove the mesh oil filter.
  1. Uncover (1) the AT hydraulic control unit.
  1. Take out the hydraulic control unit from the AT case.

Turn out only bolts with a head (A) of 12 mm.


  1. Turn the electroconducting socket to the left and pull out it.
  1. Remove a tightening bracket and press the electroconducting socket into AT case.
  1. Take out the hydraulic control unit with an electroconducting plait.
  2. Installation is made upside-down. Pay attention to the next moments.
  1. Make sure of correctness of installation of aligning pins (1). The pin (3) levers of the selector should enter into gearing with a flute of the movable valve (2).

  1. Replace sealing rings.


«previous page
9.5. Removal and PNP sensor installation
following page»
9.7. Removal and installation Ý/m valves, regulators and sensors









http://b3-b4.ru/