BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
9.1. General information
9.2. Search of malfunctions
9.3. Removal and AT installation and hydrotransformer
9.4. Removal and installation of the pallet of a case
9.5. Removal and PNP sensor installation
9.6. Removal and installation of the ATF filter and hydraulic block
9.7. Removal and installation Ý/m valves, regulators and sensors
9.8. Replacement of an arm of the mechanism of switching of AT modes
9.9. Adjustment of the balance weight of switching
9.10. Adjustment of the lever of the selector
9.11. Adjustment and check of blocking of the lever of the selector
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


шлюхи одессы снять.

9-5-snyatie-i-ustanovka-datchika-pnp.html

9.5. Removal and PNP sensor installation

Below the description on AT A5S 440Z example is provided.


 PERFORMANCE ORDER

  1. Remove the back panel of protection of auxiliary units of the engine.
  2. Remove the left and right thermofilters.
  3. Holding the tightening plug (1), give a nut (2).

At installation adjust the selector lever.

  1. Screw-driver take out a lock plate and pull out draft (2).
  2. Prop up AT No. No. 00 2 030/24 5 301/24 00 250 adaptations.
  1. Turn out bolts approximately on 10 mm and lower AT on this size.
  1. Give a nut (1) and remove the control unit balance weight (2).
  1. Turn out bolts and remove the PNP (1) sensor from an axis of the balance weight of the control unit.
  1. Separate the socket (1) and take out the socket. Take the socket (2) of a fixing corner, unclench clips on the pallet of a case and take from them a cable.


«previous page
9.4. Removal and installation of the pallet of a case
following page»
9.6. Removal and installation of the ATF filter and hydraulic block









http://b3-b4.ru/