BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
9.1. General information
9.2. Search of malfunctions
9.3. Removal and AT installation and hydrotransformer
9.4. Removal and installation of the pallet of a case
9.5. Removal and PNP sensor installation
9.6. Removal and installation of the ATF filter and hydraulic block
9.7. Removal and installation Ý/m valves, regulators and sensors
9.8. Replacement of an arm of the mechanism of switching of AT modes
9.9. Adjustment of the balance weight of switching
9.10. Adjustment of the lever of the selector
9.11. Adjustment and check of blocking of the lever of the selector
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


9-4-snyatie-i-ustanovka-poddona-kartera.html

9.4. Removal and installation of the pallet of a case

Below the description on AT A5S 310Z example is provided.


 PERFORMANCE ORDER

  1. Turn out a stopper (1) drain opening of ATF and lower ATF.
  1. Turn out bolts and remove the case pallet.
  1. Clear the pallet of a case and a magnetic disk.
  1. Enclose in the case pallet magnetic disks (1 and 2). Check sealing laying (3) and if necessary, to replace it.
  1. In corners of the pallet of a case establish the rounded-off brackets.
  1. Upon termination of works fill ATF (see. Head of Control and routine maintenance of the car).



«previous page
9.3. Removal and AT installation and hydrotransformer
following page»
9.5. Removal and PNP sensor installation









http://b3-b4.ru/