BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
8.1. Manual box of gear shifting
8.2. Coupling
8.2.1. General information
8.2.2. Removal and coupling installation
8.2.3. Replacement of the vyzhimny bearing and fork of switching off of coupling
8.2.4. Replacement of the main cylinder of coupling
8.2.5. Replacement of the executive cylinder
8.2.6. Removal and installation of a pedal of coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

8-2-5-zamena-ispolnitelnogo-cilindra.html

8.2.5. Replacement of the executive cylinder

 PERFORMANCE ORDER

  1. Remove the bottom protective casing of RKPP.
  1. Muffle an opening of the feeding pipeline going to the main cylinder of a hydraulic actuator of coupling by means of the special adaptation No. 13 3 010.
  1. Remove the pressure head pipeline from the executive cylinder of a hydraulic actuator of coupling (shooter) and give two nuts (at the left and to the right of the cylinder).

Dump depression in the executive cylinder of a hydraulic actuator of coupling gradually that through a sealing cuff in the cylinder air was not soaked up.


  1. Installation is made upside-down. Clear a pusher and the plane of its interface to a fork of switching off of coupling. Grease a pusher with a small amount of greasing.


«previous page
8.2.4. Replacement of the main cylinder of coupling
following page»
8.2.6. Removal and installation of a pedal of coupling