BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
8.1. Manual box of gear shifting
8.2. Coupling
8.2.1. General information
8.2.2. Removal and coupling installation
8.2.3. Replacement of the vyzhimny bearing and fork of switching off of coupling
8.2.4. Replacement of the main cylinder of coupling
8.2.5. Replacement of the executive cylinder
8.2.6. Removal and installation of a pedal of coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

8-2-3-zamena-vyzhimnogo-podshipnika-i-vilki-vyklyucheniya-scepleniya.html

8.2.3. Replacement of the vyzhimny bearing and fork of switching off of coupling

 PERFORMANCE ORDER

  1. Remove RKPP (see. Removal and RKPP installation).
  1. Remove the coupling (1) switching off of coupling.

At installation clear all surfaces (2) slidings of the coupling, – they should adjoin to surfaces (3) slidings of a fork of switching off of coupling. Slightly to grease surfaces of sliding (2) vyzhimny bearings.


  1. Remove a spring bracket (5) forks of switching off of coupling (4) then remove a fork.

At installation clear a fork of switching off of coupling.


  1. Slightly grease at a fork of switching off of coupling of a surface of sliding (1 and 2).
  1. Check a spring bracket (5) and a finger (6) with a spherical head on absence of damages and if necessary replace. Slightly grease a finger (6).
  1. To clear directing plug (7).

Directing plug do not grease, since jamming on it the vyzhimny bearing otherwise is possible.

  1. Installation is made upside-down.

On RKPP S6S 420G the spring bracket and a finger are subject to replacement.



«previous page
8.2.2. Removal and coupling installation
following page»
8.2.4. Replacement of the main cylinder of coupling