7.2.6. System of start of the engine - the general information and precautionary measures
The unique task of system of start of the engine is ensuring rotation of the engine with a speed, sufficient for its start.
The system of start consists of a starter, the storage battery, the switch of ignition, the traction relay and connecting electroconducting.
The starter represents the electric motor of a direct current with the mixed excitement and the electromagnetic traction relay established outside. The starter consists of the case or a stator with windings of excitement, an anchor with the obgonny coupling, covers with shchetkoderzhatel and the traction relay.
At starter inclusion through a winding of the traction relay the current from the storage battery starts to proceed. The anchor of the relay is involved and contacts become isolated. At the same time the relay anchor via the driving lever provides gear wheel promotion with the obgonny coupling, thus the nave of the coupling turns on screw shlitsa of a shaft of an anchor of a starter and turns as well a gear wheel that facilitates input of the last in gearing with a gear wreath of a flywheel. Through the closed contacts of the traction relay passes a current feeding windings of a stator and an anchor and an anchor of a starter starts to rotate together with a nave and the obgonny coupling.
After engine start frequency of rotation of a gear wheel exceeds frequency of rotation of an anchor of a starter. In this case the obgonny coupling is freely turned, and the torque is not transferred from an engine flywheel to a shaft of an anchor of a starter. After an ignition key otpuskaniye the power-supply circuit of windings of the traction relay via the switch of ignition is disconnected, the anchor of the traction relay is wrung out by a spring in a starting position, contacts of the relay are disconnected and the gear wheel of a drive leaves gearing with a gear wreath of a flywheel.
The starter with the involving relay is located parallel to a cranked shaft of the engine and fixed on the power unit.
At carrying out any works with system of start of the engine observe the following requirements:
- In order to avoid an exit э / the motor out of operation as a result of an overheat do not include a starter more than for 15 seconds, - before repeated inclusion wait for not less than 1 minute. The long provorachivaniye of not being started engine a starter leads to a congestion of not burned down fuel in the catalytic converter that is fraught with an exit of the last out of operation as a result of ignition at start implementation;
- The starter is connected directly to the storage battery and the negligent treatment of him can be at the bottom of ignition as a result of short circuit;
- Before the beginning of works on starter service always disconnect from the battery a negative wire.