BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.3. Power supply system of diesel engines
6.3.1. Principles of functioning of control systems of diesel engines
6.3.2. Removal and installation of the case of an air purifier
6.3.3. Removal and turbokompressor installation
6.3.4. Removal and installation of an interkuler
6.3.5. Replacement of the sensor of pressure of pressurization
6.3.6. Removal and installation of the sensor of pressure in the fuel distributive highway
6.3.7. Removal and installation of a regulator of pressure and fuel distributor
6.3.8. Replacement of the valve of an otsechka of supply of fuel
6.3.9. Removal and installation of fuel lines and fuel distributive highway
6.3.10. Removal and installation of the valve of preliminary heating
6.3.11. Removal and TNVD installation
6.3.12. Removal and installation of nozzles
6.3.13. Replacement of a fuel tank, his jellied mouth, and also fuel pump and sensors of a stock of fuel
6.4. Systems of release and decrease in toxicity of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

6-3-4-snyatie-i-ustanovka-interkulera.html

6.3.4. Removal and installation of an interkuler

If the established hoses of nadduvochny air are not fat-free also damp, it can lead to failure of the supercharger. Do not allow damage of plates of an interkuler.


 PERFORMANCE ORDER

  1. Remove a casing of the fan of system of cooling of the engine (see. Head of System of cooling of the engine, heating, ventilation and conditioning).
  2. Remove the forward panel of protection of auxiliary units.

Models with the M57 engine

 PERFORMANCE ORDER

  1. Unclench collars (1), remove a hose (2), disconnect a hose (3) and put it aside.
  1. Wring out clamps (1 and 2) on both parties and extend an interkuler at the same time a little.
  1. Take out an interkuler (1) in the direction specified by shooters.
  1. If necessary replace an arm. For this purpose wring out a screw-driver a bracket (1) up and remove an arm (2).
  1. Installation is made upside-down.

Models with the M67 engine

 PERFORMANCE ORDER

  1. Weaken collars (1 and 3) and disconnect pressure head sleeves (2 and 4).
  1. Execute the actions specified in paragraphs 2-5.


«previous page
6.3.3. Removal and turbokompressor installation
following page»
6.3.5. Replacement of the sensor of pressure of pressurization