BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.2.1. Principles of functioning of a control system of the petrol engine
6.2.2. Removal and installation of the case of an air purifier
6.2.3. Removal and branch pipe installation between a flowmeter of air and the butterfly valve case
6.2.4. Removal and installation of the case of a throttle, replacement of its laying
6.2.5. Removal and IAC valve installation
6.2.6. Removal and installation of the fuel distributive highway and injectors
6.2.7. Replacement of a regulator of pressure of fuel
6.2.8. Removal and installation of the fuel pump
6.2.9. Removal and installation of sensors of a stock of fuel
6.2.10. Removal and installation of a fuel tank
6.2.11. Removal and installation of a fuel jellied mouth
6.3. Power supply system of diesel engines
6.4. Systems of release and decrease in toxicity of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




buy viagra online 0c1943ba

6-2-8-snyatie-i-ustanovka-toplivnogo-nasosa.html

6.2.8. Removal and installation of the fuel pump

 PERFORMANCE ORDER

  1. Empty a fuel tank.
  2. Remove the sensor of a stock of fuel in the right part of a fuel tank (see. Section Removal and installation of sensors of a stock of fuel).
  1. Separate both sockets of electroconducting (1) on the fuel pump, unclench two collars (black shooters) electroconducting plait, weaken a collar and accurately disconnect a spiral hose in the direction of a white arrow, without allowing damage of the union of the pump.

  1. Installation is made upside-down. Before installation straighten a connecting hose and a cable (1) between a cover (2) and the fuel pump (3) to avoid a tension.


«previous page
6.2.7. Replacement of a regulator of pressure of fuel
following page»
6.2.9. Removal and installation of sensors of a stock of fuel