BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.2.1. Principles of functioning of a control system of the petrol engine
6.2.2. Removal and installation of the case of an air purifier
6.2.3. Removal and branch pipe installation between a flowmeter of air and the butterfly valve case
6.2.4. Removal and installation of the case of a throttle, replacement of its laying
6.2.5. Removal and IAC valve installation
6.2.6. Removal and installation of the fuel distributive highway and injectors
6.2.7. Replacement of a regulator of pressure of fuel
6.2.8. Removal and installation of the fuel pump
6.2.9. Removal and installation of sensors of a stock of fuel
6.2.10. Removal and installation of a fuel tank
6.2.11. Removal and installation of a fuel jellied mouth
6.3. Power supply system of diesel engines
6.4. Systems of release and decrease in toxicity of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

6-2-11-snyatie-i-ustanovka-toplivnojj-zalivnojj-gorloviny.html

6.2.11. Removal and installation of a fuel jellied mouth

 PERFORMANCE ORDER

  1. Empty a fuel tank.
  2. Remove the right back wheel and a loker of a back right wheel arch.
  1. Separate the EVAP pipeline.
  1. Remove a hose of connection of a mouth with a fuel tank (see an illustration).
  1. Give the bottom fixture of a mouth.
  1. Give the top fixture of a mouth.
  1. Take out mouth assembly from a rubber cuff on a wheel arch.
  2. Installation is made upside-down. After installation of a mouth measure electric resistance between a grounding tag (at a jellied mouth of a fuel tank) and a wheel nave – it should make about 0.6 Ohm.


«previous page
6.2.10. Removal and installation of a fuel tank
following page»
6.3. Power supply system of diesel engines