BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
4.7.1. Removal and installation of a cover of a head of cylinders
4.7.2. Removal and installation of heads of cylinders
4.7.3. Removal and installation of the top section of the pallet of a case
4.7.4. Removal and installation of the pallet of a case
4.7.5. Replacement of epiploons of a cranked shaft
4.7.6. Replacement of an oil separator of PCV system
4.7.7. Removal and flywheel installation
4.7.8. Removal and installation of a damper of krutilny fluctuations
4.7.9. Removal and installation of driving belts and their natyazhitel
4.7.10. Removal and installation of the oil pump
4.7.11. Removal and installation of maslookhladitel
4.7.12. Removal and installation of the inlet pipeline
4.7.13. Removal and installation of final collectors
4.7.14. Removal and installation of the vacuum pump
4.7.15. Removal and engine installation
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


4-7-8-snyatie-i-ustanovka-dempfera-krutilnykh-kolebanijj.html

4.7.8. Removal and installation of a damper of krutilny fluctuations

 PERFORMANCE ORDER

  1. Remove protection of a case.
  2. Remove driving belts (see. Section Removal and installation of driving belts and their natyazhitel).
  1. Turn out bolts in the lower part of a transmission.
  1. Weaken a bolt (1), shift the sliding coupling (2) against the stop down, fix the adaptation No. 11 8 181 on a transmission, insert and tighten bolts (3).
  1. Turn a cranked shaft in a damper of krutilny fluctuations by means of the adaptation No. 11 6 480 until the sliding coupling of the adaptation No. 11 8 180 will not enter into a gear wreath.
  1. Fix a flywheel for what move the sliding coupling (1) up against the stop to a gear wreath of a flywheel and tighten a bolt (2).
  1. Turn out bolts (1) damper (2) krutilny fluctuations.
  2. Installation is made in return sequence, use new bolts of fastening of a damper of krutilny fluctuations.


«previous page
4.7.7. Removal and flywheel installation
following page»
4.7.9. Removal and installation of driving belts and their natyazhitel









http://b3-b4.ru/