BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
4.7.1. Removal and installation of a cover of a head of cylinders
4.7.2. Removal and installation of heads of cylinders
4.7.3. Removal and installation of the top section of the pallet of a case
4.7.4. Removal and installation of the pallet of a case
4.7.5. Replacement of epiploons of a cranked shaft
4.7.6. Replacement of an oil separator of PCV system
4.7.7. Removal and flywheel installation
4.7.8. Removal and installation of a damper of krutilny fluctuations
4.7.9. Removal and installation of driving belts and their natyazhitel
4.7.10. Removal and installation of the oil pump
4.7.11. Removal and installation of maslookhladitel
4.7.12. Removal and installation of the inlet pipeline
4.7.13. Removal and installation of final collectors
4.7.14. Removal and installation of the vacuum pump
4.7.15. Removal and engine installation
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

4-7-7-snyatie-i-ustanovka-makhovika.html

4.7.7. Removal and flywheel installation

 PERFORMANCE ORDER

  1. Remove RKPP together with coupling or AT (see. Head Manual box of gear shifting and coupling or Automatic transmission).
  2. Fix a flywheel by means of the special adaptation No. 11 2 070 (see an illustration).
  1. Turn out bolts of fastening of a flywheel and remove it.
  1. Check a condition of the aligning plug of a flywheel and if necessary replace it.

On models with RKPP/AT plugs of different length are used.

  1. Clear all carving openings of a cranked shaft, establish a flywheel and tighten bolts of its fastening in a cross order.


«previous page
4.7.6. Replacement of an oil separator of PCV system
following page»
4.7.8. Removal and installation of a damper of krutilny fluctuations