BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
4.7.1. Removal and installation of a cover of a head of cylinders
4.7.2. Removal and installation of heads of cylinders
4.7.3. Removal and installation of the top section of the pallet of a case
4.7.4. Removal and installation of the pallet of a case
4.7.5. Replacement of epiploons of a cranked shaft
4.7.6. Replacement of an oil separator of PCV system
4.7.7. Removal and flywheel installation
4.7.8. Removal and installation of a damper of krutilny fluctuations
4.7.9. Removal and installation of driving belts and their natyazhitel
4.7.10. Removal and installation of the oil pump
4.7.11. Removal and installation of maslookhladitel
4.7.12. Removal and installation of the inlet pipeline
4.7.13. Removal and installation of final collectors
4.7.14. Removal and installation of the vacuum pump
4.7.15. Removal and engine installation
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


4-7-4-snyatie-i-ustanovka-poddona-kartera.html

4.7.4. Removal and installation of the pallet of a case

 PERFORMANCE ORDER

  1. Lower impellent oil (see. Head of Control and routine maintenance of the car).
  1. Turn a roller of a natyazhitel on the screw (1) in the direction specified by an arrow. Take aside a driving belt (2).
  1. Turn out a bolt (1), unclench a collar (2) plaits of electroconducting.
  1. Separate the socket (1), turn out bolts (2) and remove the pump GUR (3) from the top section of the pallet of a case.
  1. Fix the pump GUR (1) aside, turn out all bolts (2) bottom sections of the pallet of a case of m remove it.

At installation pay attention to the provision of an arm (3).

  1. Clear interfaced surfaces and replace laying of the pallet of a case.
  2. Rearrange To the/l switch of low level of oil on the new pallet of a case.
  3. Installation is made upside-down.



«previous page
4.7.3. Removal and installation of the top section of the pallet of a case
following page»
4.7.5. Replacement of epiploons of a cranked shaft