BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.6. Diesel M57 engine
4.6.1. Removal and installation of a head of cylinders, camshafts and their asterisks
4.6.2. Removal and installation of the top section of the pallet of a case
4.6.3. Removal and installation of a cover of a drive of GRM
4.6.4. Replacement of epiploons of a cranked shaft
4.6.5. Removal and flywheel installation
4.6.6. Removal and installation of a damper of krutilny fluctuations
4.6.7. Replacement of driving belts and their natyazhitel
4.6.8. Removal and installation of the oil pump
4.6.9. Removal and installation of a maslookhladitel
4.6.10. Removal and installation of the inlet pipeline
4.6.11. Removal and installation of a final collector
4.6.12. Removal and installation of the vacuum pump
4.6.13. Removal and engine installation
4.7. Diesel M67 engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

4-6-9-snyatie-i-ustanovka-maslookhladitelya.html

4.6.9. Removal and installation of a maslookhladitel

 PERFORMANCE ORDER

  1. Remove protection of a case.
  2. Lower cooling liquid (see. Head of Control and routine maintenance of the car).
  3. Remove the case of the oil filter.

At removal of the case of the oil filter the remained quantity of OZh flows down from a maslookhladitel in the pallet of a case of the engine therefore in order to avoid engine damage because of OZh hit in impellent oil it is necessary to replace impellent oil after completion of works.

  1. Cover the generator to prevent its pollution.
  1. Turn out bolts of fastening of a maslookhladitel (1) and remove it from the case (2) of the oil filter. If necessary rearrange a hose of system of cooling.
  1. Replace profile laying on the case of the oil filter.
  2. Clear interfaced surfaces of a case of the engine, the case of the oil filter and a maslookhladitel.
  3. Establish the removed components in sequence, return sequence of their dismantle.
  4. Replace impellent oil (see. Head of Control and routine maintenance of the car).


«previous page
4.6.8. Removal and installation of the oil pump
following page»
4.6.10. Removal and installation of the inlet pipeline