BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.6. Diesel M57 engine
4.6.1. Removal and installation of a head of cylinders, camshafts and their asterisks
4.6.2. Removal and installation of the top section of the pallet of a case
4.6.3. Removal and installation of a cover of a drive of GRM
4.6.4. Replacement of epiploons of a cranked shaft
4.6.5. Removal and flywheel installation
4.6.6. Removal and installation of a damper of krutilny fluctuations
4.6.7. Replacement of driving belts and their natyazhitel
4.6.8. Removal and installation of the oil pump
4.6.9. Removal and installation of a maslookhladitel
4.6.10. Removal and installation of the inlet pipeline
4.6.11. Removal and installation of a final collector
4.6.12. Removal and installation of the vacuum pump
4.6.13. Removal and engine installation
4.7. Diesel M67 engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

4-6-12-snyatie-i-ustanovka-vakuumnogo-nasosa.html

4.6.12. Removal and installation of the vacuum pump

 PERFORMANCE ORDER

  1. Remove forward section of the top cover of the engine.
  1. Disconnect from the vacuum pump a vacuum hose (1), turn out bolts (2) and nanosecond the vacuum pump.

The carving of bolts is covered with hermetic. At installation use new bolts or put on old bolts Drei Bond 1209 hermetic.


  1. Replace a sealing ring (1) and put with a thin layer greasing for sliding improvement. Expose a lead (2) vacuum pumps concerning grooves on a camshaft asterisk.
  1. Further installation is made upside-down.


«previous page
4.6.11. Removal and installation of a final collector
following page»
4.6.13. Removal and engine installation