BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.4.1. Removal and installation of a cover of a head of cylinders
4.4.2. Removal and installation of a head of cylinders, adjustment of phases GRM
4.4.3. Removal and installation of the top section of the pallet of a case
4.4.4. Removal and installation of the pallet of a case
4.4.5. Removal and installation of covers of a chain of GRM
4.4.6. Replacement of epiploons of a cranked shaft
4.4.7. Removal and flywheel installation
4.4.8. Removal and installation of belts of a drive of auxiliary units
4.4.9. Removal and installation of a damper of krutilny fluctuations and its nave
4.4.10. Removal and installation of the oil pump
4.4.11. Removal and installation of the inlet pipeline
4.4.12. Removal and installation of final collectors
4.4.13. Removal and engine installation
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


4-4-benzinovye-dvigateli-m60-1-i-m60-2.html

4.4. Petrol M60/1 and M60/2 engines

Removal and installation of a cover of a head of cylinders

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the storage battery.
  2. Remove the top casing of the engine.
  3. Remove the top cover of an air purifier together with the MAF sensor (see. The section Replacement of a filtering element of an air purifier of Head of Control and routine maintenance of the car).
  1. Remove plastic covers and the coils of ignition located under them.
  1. Turn out bolts of fastening and take away to the middle the left and right cable boxes.
  1. Disconnect a wire from plusovy contact of the storage battery in an impellent compartment (see illustrations Components of an impellent compartment of models with the M52 engine, Components of an impellent compartment of models with the M51 engine, Components of an impellent compartment of models with the M62 engine).
  1. Give fixture and uncover heads of cylinders.
  1. Check a condition of laying of a cover of a head of cylinders and if necessary replace laying.
  1. Clear condensed surfaces of the remains of laying and grease stykovochny surfaces with Drei Bond 1209 hermetic.
Places of drawing of hermetic
  1. Establish a cover of a head of cylinders, center it on several bolts then tighten bolts of fastening of a cover with demanded effort in sequence from the middle to edges.


«previous page
4.3. Engine check by means of the vacuum gage
following page»
4.4.1. Removal and installation of a cover of a head of cylinders









http://b3-b4.ru/