BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.4.1. Removal and installation of a cover of a head of cylinders
4.4.2. Removal and installation of a head of cylinders, adjustment of phases GRM
4.4.3. Removal and installation of the top section of the pallet of a case
4.4.4. Removal and installation of the pallet of a case
4.4.5. Removal and installation of covers of a chain of GRM
4.4.6. Replacement of epiploons of a cranked shaft
4.4.7. Removal and flywheel installation
4.4.8. Removal and installation of belts of a drive of auxiliary units
4.4.9. Removal and installation of a damper of krutilny fluctuations and its nave
4.4.10. Removal and installation of the oil pump
4.4.11. Removal and installation of the inlet pipeline
4.4.12. Removal and installation of final collectors
4.4.13. Removal and engine installation
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

4-4-9-snyatie-i-ustanovka-dempfera-krutilnykh-kolebanijj-i-ego-stupicy.html

4.4.9. Removal and installation of a damper of krutilny fluctuations and its nave

Damper of krutilny fluctuations

 PERFORMANCE ORDER

  1. Remove driving belts (see. Section Removal and installation of belts of a drive of auxiliary units).
  1. Turn out bolts and remove a damper of krutilny fluctuations.

The provision of a damper is defined by an aligning pin.

  1. Installation is made upside-down. Use new bolts of fastening of a damper.

Damper nave

 PERFORMANCE ORDER

  1. Remove a damper of krutilny fluctuations.
  1. Disconnect a branch pipe обдува the generator.
  1. Remove the left and right channels обдува brake mechanisms. If necessary remove a hose of supply of additional air (see. Head of the Power supply system and production of the fulfilled gases). Remove the holder of a branch pipe from an engine support.
  1. Pay attention to the provision of an aligning pin.
  1. Establish the adaptation No. 11 2 450.

Not to allow damage of a support of the engine, between a support and the adaptation No. 11 2 450 lay wooden whetstone.

  1. Turn out the central bolt and remove a nave of a damper of krutilny fluctuations.
  2. Installation is made upside-down. Use a new bolt of fastening of a nave.


«previous page
4.4.8. Removal and installation of belts of a drive of auxiliary units
following page»
4.4.10. Removal and installation of the oil pump