BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of kompressionny pressure
4.3. Engine check by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.4.1. Removal and installation of a cover of a head of cylinders
4.4.2. Removal and installation of a head of cylinders, adjustment of phases GRM
4.4.3. Removal and installation of the top section of the pallet of a case
4.4.4. Removal and installation of the pallet of a case
4.4.5. Removal and installation of covers of a chain of GRM
4.4.6. Replacement of epiploons of a cranked shaft
4.4.7. Removal and flywheel installation
4.4.8. Removal and installation of belts of a drive of auxiliary units
4.4.9. Removal and installation of a damper of krutilny fluctuations and its nave
4.4.10. Removal and installation of the oil pump
4.4.11. Removal and installation of the inlet pipeline
4.4.12. Removal and installation of final collectors
4.4.13. Removal and engine installation
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

4-4-4-snyatie-i-ustanovka-poddona-kartera.html

4.4.4. Removal and installation of the pallet of a case

The description provided below is suitable also for M62 engines.


 PERFORMANCE ORDER

  1. Remove protection of a case of the engine.
  2. Turn out a cover of the oil filter and a stopper of a drain opening in the case pallet. Lower impellent oil.
  1. Separate the socket of electroconducting of the sensor of inclusion To/l oil level.
  1. Turn out bolts of fastening of the pallet of a case and remove it.
  1. Clear interfaced surfaces of the remains of sealing materials.
  1. Installation is made upside-down. Use new laying and new bolts. For convenience of installation use pins.


«previous page
4.4.3. Removal and installation of the top section of the pallet of a case
following page»
4.4.5. Removal and installation of covers of a chain of GRM