BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
3.1. General information
3.2. General information about settings and adjustments
3.3. Schedule of routine maintenance
3.4. Check of levels of liquids, control of leaks
3.5. Check of a condition and replacement of hoses and tubes in an impellent compartment, localization of leaks
3.6. Replacement of impellent oil and oil filter
3.7. Pro-cleaning and replacement of the fuel filter
3.8. Check of brake system and coupling
3.9. Check of a condition of system of production of the fulfilled gases
3.10. Check of a condition of components of a suspension bracket and steering
3.11. Check of a condition of protective covers of CV JOINTS of power shafts
3.12. AT transmission oil replacement
3.13. Replacement of brake liquid and pumping of brake system
3.14. Replacement of spark plugs
3.15. Replacement of the salonny filter (ventilation system)
3.16. Replacement of a filtering element of an air purifier
3.17. Replacement of cooling liquid
3.18. Check of a condition of tires and pressure of their rating
3.19. Check of a condition of the battery and care of it
3.20. Check of a condition of a belt of a drive of auxiliary units
3.21. Check of a condition of brushes of screen wipers and adjustment of nozzles of washers
3.22. Replacement of oil of the main transfer
3.23. Check of thickness of a conducted disk of coupling
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


3-12-zamena-transmissionnogo-masla-at.html

3.12. AT transmission oil replacement

Below the description of replacement of ATF is provided. Replacement of the RKPP transmission oil is made similarly.


 PERFORMANCE ORDER

  1. Warm up ATF liquid and switch off the engine.
  1. Turn out a drain stopper and lower ATF in in advance prepared capacity. Check ATF condition.

Jellied stopper of AT A5S 560Z

  1. Tighten a drain stopper with new consolidation with demanded effort and turn out a stopper of a jellied opening.
  1. At the switched-off engine fill AT with liquid so that it started to follow from a jellied opening.
  2. Start the engine, transfer the selector lever to the situation "P".Включите a passing beam (the selector lever in the situation "N").
  3. Again add ATF that it started to follow from a jellied opening. Then tighten a stopper of a jellied opening with new consolidation and with demanded effort.
  4. Squeeze out a brake pedal, establish a winter operating mode of AT and translate the selector lever through all provisions. Check AT level by means of the diagnostic device.
  5. Approximately in 5 minutes of operation of the engine make sure of absence of leakages of ATF.


«previous page
3.11. Check of a condition of protective covers of CV JOINTS of power shafts
following page»
3.13. Replacement of brake liquid and pumping of brake system









http://b3-b4.ru/