BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
14.1. General information, diagnostics of malfunctions
14.2. Lighting devices
14.2.1. Adjustment of headlights
14.2.2. Removal and installation of headlights and their components
14.2.3. Removal and installation of other devices of external lighting
14.2.4. Removal and installation of devices of internal lighting
14.2.5. Replacement of lamps of devices of external lighting
14.2.6. Replacement of lamps of devices of internal lighting
14.3. Screen wipers and washers
14.4. Other electric equipment
15. Electric equipment schemes




0c1943ba

14-2-6-zamena-lamp-priborov-vnutrennego-osveshheniya.html

14.2.6. Replacement of lamps of devices of internal lighting

Lamps of the main salonny lamp

 PERFORMANCE ORDER

  1. Remove the ceiling lamp in collecting (see. Section Removal and installation of devices of internal lighting).
  2. On models with lamps of individual lighting turn a cartridge of the corresponding lamp counter-clockwise and remove it. Take out a lamp.
1 — the Boss of a lamp of the left individual lamp
2 — the Boss of the main salonny lamp
3 — the Boss of a lamp of the right individual lamp
  1. On models without lamps of individual lighting turn out screws (1), remove the ceiling lamp (2) from the rasseivatel who was under it and remove lamps.

Lamp of a lamp of illumination of a cosmetic mirror

 PERFORMANCE ORDER

  1. Remove a lamp of illumination of a mirror (see. Section Removal and installation of devices of internal lighting).
  1. Unclench contact arches (1) and remove a lamp (2).

Light-emitting diode of illumination of internal handles of doors

 PERFORMANCE ORDER

  1. Remove door furnish (see. Head Body).
  1. Disconnect a light-emitting diode with a cable (1) from a flask (2).
  1. Cut off a cable (1) light-emitting diode in length (And = 10 cm) from a plait of electroconducting of a door.
  1. Cut off the end of a wire of a new light-emitting diode in length 16 see.
  2. Connect a plait of electroconducting of a door and a light-emitting diode cable by means of a butt connector and кембриков.
  3. Fix a repair site on a plait of electroconducting of a door.


«previous page
14.2.5. Replacement of lamps of devices of external lighting
following page»
14.3. Screen wipers and washers