BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
13.1. External equipment and body elements
13.2. Salon equipment
13.2.1. Removal and installation of window regulators
13.2.2. Removal and installation of furnish and sound insulation of a forward door
13.2.3. Removal and installation of furnish and sound insulation of a back door
13.2.4. Removal and installation of panels of furnish of racks of a body and ceiling
13.2.5. Removal and installation of furnish of the dashboard
13.2.6. Removal and shelf installation behind a back seat and shtorka of back glass
13.2.7. Removal and installation of overlays of thresholds of doors
13.2.8. Removal and installation of elements of furnish of a luggage compartment and its cover
13.2.9. Removal and installation of forward seats
13.2.10. Removal and installation of a back seat
13.2.11. Removal and installation of seat belts
13.2.12. Removal and installation of a cover of the top hatch
14. Onboard electric equipment
15. Electric equipment schemes


13-2-oborudovanie-salona.html

13.2. Salon equipment

Removal and installation of window regulators

Forward door

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the storage battery.
  2. Adjust the provision of glass of a forward door (see. Section Replacement and adjustment of mobile glasses of doors).
  3. On models with a lateral safety cushion remove it.
  1. Unhook and remove the internal handle of a door.
  1. Wring out down a socket clamp, move the lever down and separate the socket (1) electroconducting of loudspeaker. Turn out bolts and remove a box (2) dynamics.
  1. Separate the socket (1), turn out bolts (3) and remove the control unit (4). Cut collars of fastening of a plait of electroconducting and remove holders (2) electroconductings (a rivet with rasporny plugs). Completely remove a sound-proof covering.
  1. Lift glass (1) up and fix it in this situation with the help of a wooden wedge (2). Separate the socket of electroconducting of a drive of a window regulator, turn out bolts (3 bottom bolts only to weaken) and remove a hummock drive of a window regulator assembled.
  1. Installation is made upside-down. Pay attention to the next moments.
  1. Establish a window regulator in an angular arm and insert all bolts, without tightening them it is final. Tighten bolts (1 and 2).
  1. Insert glass into clips of a window regulator and adjust the provision of glass.
  1. Lower glass against the stop and tighten bolts (3 and 4).
  1. Lift glass against the stop and tighten bolts (5 and 6).

Back door

 PERFORMANCE ORDER

  1. Remove glass of a back door (see. Section Replacement and adjustment of mobile glasses of doors).
  1. Turn out bolts, separate the socket and remove a window regulator (1).


«previous page
13.1.7. Replacement and adjustment of mobile glasses of doors
following page»
13.2.1. Removal and installation of window regulators









http://b3-b4.ru/