BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
13.1. External equipment and body elements
13.1.1. Removal and installation of a forward wing
13.1.2. Removal, installation and adjustment of doors
13.1.3. Removal, installation and cowl adjustment, replacement of its racks
13.1.4. Removal, installation and adjustment of a cover of a luggage compartment, replacement of its components
13.1.5. Removal and installation of a front bumper and its components
13.1.6. Removal and installation of a rear bumper and its components
13.1.7. Replacement and adjustment of mobile glasses of doors
13.2. Salon equipment
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

13-1-7-zamena-i-regulirovka-podvizhnykh-stekol-dverejj.html

13.1.7. Replacement and adjustment of mobile glasses of doors

Replacement of glass of a forward door

 PERFORMANCE ORDER

  1. Remove an external protective molding of a window and adjust the provision of glass of a door.
  2. On models with a lateral safety cushion remove it.
  3. Take out glass movement back/up, deducing it from the outer side of a frame

Adjustment of glass of a forward door

 PERFORMANCE ORDER

  1. Remove door furnish (see. Section Removal and installation of furnish and sound insulation of a forward door).
  2. On models with a lateral safety cushion remove it.
  1. Disconnect back edge of sound insulation that the bottom screws became available, and fix the screen a sticky tape (1).
  1. Connect the switch of window regulators to the socket of a plait of electroconducting at doors and release glass of a forward door.
  1. Weaken screws and lift glass before formation of a crack of 10 mm from a door edge. Disconnect the switch of window regulators.
  1. At installation adjust the provision of glass in the longitudinal direction and on height (parallelism). For this purpose shift glass in the weakened tightening blocks in the longitudinal direction, then raise a back tightening block (thus glass should roll in tightening blocks) and tighten at first the screw back, and then – a forward block.
  1. Adjust size of a gap (A) and (B) between an edge (forward and top) flew down also an overlay of a window frame. (A) = 5.4 mm, and (B) = 10 mm.

Replacement of glass of a back door

 PERFORMANCE ORDER

  1. Remove sound insulation of a back door.
  2. Extend external bottom consolidation and lateral rubber directing glasses.
  1. Verify screws and remove a slip.
  1. Turn out the screw and lift door glass up.
  1. Incline glass of a door and take out it movement up, having pulled back edge forward/outside.


«previous page
13.1.6. Removal and installation of a rear bumper and its components
following page»
13.2. Salon equipment