BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
12.5.1. Principle of work of GUR
12.5.2. Removal and installation of a steering wheel, block of a safety cushion and its contact ring
12.5.3. Removal and installation of casings of a steering column
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
12.5.5. Replacement of the lever of adjustment of a steering column
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
12.5.7. Removal and installation of the steering mechanism with GUR
12.5.8. Removal and installation of steering drafts, soshka and pendular lever
12.5.9. Removal and pump GUR installation
12.5.10. Corners of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


12-5-5-zamena-rychaga-regulirovki-rulevojj-kolonki.html

12.5.5. Replacement of the lever of adjustment of a steering column

Design of the lever of adjustment of a steering column

1 — the Nut
2 — the Bearing
3 — Tightening a disk

4 — the Clamp
5 — the Lever
8 — Torsionnaya a spring
9 — the Tightening adaptation


 PERFORMANCE ORDER

  1. Remove the top and bottom casings of a steering column (see. Section Removal and installation of casings of a steering column).
  2. Remove the wooden panel and the finishing panel of a ware box at the left.
  3. Liberate a torsionny spring (8) from both parties, give a nut (1) and remove the persistent bearing (2), tightening a disk (3) and a clamp (4).
  1. Vypressuyte by means of the special adaptation No. 32 1 200 and a nozzle No. 32 1 204 the tightening adaptation (9) from the lever (5) of adjustment of a steering column. Hold the adaptation for лыски a wrench.
  1. The lever of adjustment should look at the lock of a shaft of a steering column, and the tetrahedral head of the tightening adaptation should be got in an opening of a pipe of an arm of fastening of a steering shaft.
  1. Press the tightening adaptation (9) by means of the special adaptation No. 32 1 200 in the lever (5) of adjustment of a steering column. Put on a clamp (4), tightening a disk (3) and the persistent bearing (2). Insert a torsionny spring (8) from both parties.

Replace a nut (1).



«previous page
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
following page»
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel









http://b3-b4.ru/