BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
12.5.1. Principle of work of GUR
12.5.2. Removal and installation of a steering wheel, block of a safety cushion and its contact ring
12.5.3. Removal and installation of casings of a steering column
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
12.5.5. Replacement of the lever of adjustment of a steering column
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
12.5.7. Removal and installation of the steering mechanism with GUR
12.5.8. Removal and installation of steering drafts, soshka and pendular lever
12.5.9. Removal and pump GUR installation
12.5.10. Corners of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


12-5-4-snyatie-i-ustanovka-sborki-rulevojj-kolonki-i-datchika-ugla-povorota.html

12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the storage battery.
  2. Remove a steering wheel (see. Section Removal and installation of a steering wheel, block of a safety cushion and its contact ring).
  3. Remove the bottom section dashboard facing (see. Head Body).
  1. Remove a ring with bore (1).

At installation pay attention to the provision of a ring (1) in relation to a spring lock ring (2).

  1. To remove the top casing of a steering column (see. Section Removal and installation of casings of a steering column).
  1. At the corresponding complete set disconnect draft of Interlock system from the ignition lock.
  1. Turn out tightening a bolt and press on a steering shaft of the helmsman in the direction down.

At installation replace самоконтрящуюся a nut.


  1. If necessary remove the sensor of an angle of rotation from a steering shaft.
  1. Cut down the disposable screw a chisel or cut off its head.

At installation establish the rasporny plug and tighten the disposable screw to an obryvaniye it on a neck.


  1. Disconnect all wires conducting to a steering column, turn out the screw and separate the socket of the lock of ignition.
  1. On models with automatic adjustment turn out bolts (3).
1 — the Arm
2 — Prostavochnaya the plug
3 — the Bolt
4 — the Plastic plug
5 — the Washer
6 — Samokontryashchayasya a nut (8 Nanometers are subject to replacement,)
  1. Turn out bolts of fastening of a bearing pipe and remove a steering column.
  1. Installation is made upside-down. After installation:
    • Establish compliance between an angle of rotation for EDC and DSC systems and the actual corner.
    • Check freedom of a course of a steering column on all range of adjustment in relation to the next details/pipelines.


«previous page
12.5.3. Removal and installation of casings of a steering column
following page»
12.5.5. Replacement of the lever of adjustment of a steering column









http://b3-b4.ru/