BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.3.1. Removal and installation of assembly of a beam of a back suspension bracket
12.3.2. Removal and installation of levers and extensions of a back suspension bracket
12.3.3. Removal and installation of the stupichny bearing and its support
12.3.4. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

12-3-4-snyatie-i-ustanovka-razborka-i-sborka-stojjki-podveski.html

12.3.4. Removal and installation, dismantling and assembly of a rack of a suspension bracket

Procedure of dismantling and assembly of a rack of a back suspension bracket is similar to the corresponding procedure for a forward suspension bracket (see. Part Forward suspension bracket). Only removal and rack installation below is described.

Components of assembly of a rack of a back suspension bracket

1 — the Shock-absorber
2 — the Bottom support of a spring
3 — the Boot or the goffered cover and elements of its fastening
4 — the Chipper
5 — the Basic plate
6 — the Top support of a rack

7 — the Plate
8 — Samokontryashchayasya a nut
9 — the Top isolating laying of a spring
10 — the Spring
11 — the Adapter performed by for countries of Eastern Europe with bad roads


 PERFORMANCE ORDER

  1. Remove a shelf covering behind a back seat.
  2. Remove a wheel.
  3. Remove a brake support and tie up it on a body (see. Head Brake system).
  1. Uncover the shock-absorber and give nuts. At the corresponding complete set separate the EDC system socket.

At installation use new самоконтрящиеся nuts.


  1. Give a nut.

At installation on a finger and in an opening there should not be greasing traces. Use a new nut.


  1. Disconnect the shock-absorber from a support of the stupichny bearing.

At installation the head (1) with лысками the rezinometallichesky hinge should be turned to a bolt head.

  1. Remove a rack of a back suspension bracket.
  2. Installation is made upside-down.


«previous page
12.3.3. Removal and installation of the stupichny bearing and its support
following page»
12.4. EDC system