BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.3.1. Removal and installation of assembly of a beam of a back suspension bracket
12.3.2. Removal and installation of levers and extensions of a back suspension bracket
12.3.3. Removal and installation of the stupichny bearing and its support
12.3.4. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

12-3-3-snyatie-i-ustanovka-stupichnogo-podshipnika-i-ego-opory.html

12.3.3. Removal and installation of the stupichny bearing and its support

Procedure of replacement of the stupichny bearing of a back wheel is similar to the corresponding procedure for a forward suspension bracket (see. Part Forward suspension bracket). Removal and installation of a support of the stupichny bearing below is described.


 PERFORMANCE ORDER

  1. Vypressuyte a power shaft from a nave of the corresponding wheel (see. Section Removal and installation of power shafts of Head Kardanny and power shafts, reducer, differential and stupichny assemblies).
  2. Remove razzhimny the mechanism of brake shoes, a support and the wheel sensor of ABS system (see. Head Brake system).
  3. Remove pushing bar / the integrated lever (see. Section Removal and installation of levers and extensions of a back suspension bracket).
  1. Disconnect the shock-absorber from a support of the stupichny bearing.

At installation the head (1) with лысками the rezinometallichesky hinge should be turned to a bolt head.


  1. Give nuts and remove a support of the stupichny bearing.

At installation on fingers of nuts and in openings there should not be greasing traces. Use new nuts.

  1. Installation is made upside-down. In summary check and adjust corners of installation of back wheels.


«previous page
12.3.2. Removal and installation of levers and extensions of a back suspension bracket
following page»
12.3.4. Removal and installation, dismantling and assembly of a rack of a suspension bracket