BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.3.1. Removal and installation of assembly of a beam of a back suspension bracket
12.3.2. Removal and installation of levers and extensions of a back suspension bracket
12.3.3. Removal and installation of the stupichny bearing and its support
12.3.4. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

12-3-2-snyatie-i-ustanovka-rychagov-i-rastyazhek-zadnejj-podveski.html

12.3.2. Removal and installation of levers and extensions of a back suspension bracket

Pushing bar / the integrated lever

If at dismantle the integrated lever was disconnected from a wheel shaking a lever/support, after installation it is necessary to make measurement and/or adjustments of parameters of a running gear.


 PERFORMANCE ORDER

  1. Remove a back wheel and disconnect a power shaft from a reducer of the back bridge (see. Head Kardanny and power shafts, reducer, differential and stupichny assemblies).
  1. To facilitate installation of a corner of disorder, mark with a core the provision of an ekstsentrikovy bolt in relation to the shaking lever.
  1. Give a nut and a bolt. Turn out an ekstsentrikovy bolt and to remove the integrated lever.
  1. Installation is made upside-down. Replace a nut of an ekstsentrikovy bolt.

The shaking lever

 PERFORMANCE ORDER

  1. Remove a wheel and disconnect electroconducting of the wheel sensor of ABS system (see. Head Brake system). To facilitate installation of a corner of disorder, mark with a core the provision of an ekstsentrikovy bolt in relation to the shaking lever (see an illustration).
  1. Give a nut of an ekstsentrikovy bolt and take out it.
  1. Installation is made upside-down. Replace a nut of an ekstsentrikovy bolt. Check and adjust corners of installation of back wheels.

Top cross-section lever

If at dismantle the cross-section lever of a suspension bracket was disconnected from a beam of the back bridge, after installation it is necessary to make check and adjustment of corners of installation of back wheels.


 PERFORMANCE ORDER

  1. Remove a back wheel and disconnect the shock-absorber from a wheel support (see. Section Removal and installation, dismantling and assembly of a rack of a suspension bracket).
  2. Give nuts.
Nut of fastening of the top cross-section lever
Nut of fastening of the top cross-section lever

At installation use new самоконтрящиеся nuts.

  1. Clear of dirt and greasing a conic pin and an opening in a wheel support.
  2. Installation is made upside-down.

Extension

 PERFORMANCE ORDER

  1. Remove a wheel and give nuts.
  1. Remove an extension.
  2. Installation is made upside-down. On a finger and in an opening there should not be greasing traces. Use new nuts.
  3. Upon termination of installation check and adjust corners of installation of back wheels.


«previous page
12.3.1. Removal and installation of assembly of a beam of a back suspension bracket
following page»
12.3.3. Removal and installation of the stupichny bearing and its support