BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and suspension bracket installation assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross-section lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross-section stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


12-2-perednyaya-podveska.html

12.2. Forward suspension bracket

Removal and suspension bracket installation assembled

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the storage battery.
  2. Establish the engine in assembly situation as it is described in the Section Removal and installation of the pallet of a case in Head the Engine.
  3. Remove forward brake disks and separate sockets of electroconducting of forward wheel ABS sensors and the forward sensor of wear of brake shoes (see. Head Brake system).
  4. Remove protection of a case of the engine and to disconnect the left and right pillows of fastening of the engine from a cross-section beam of the forward bridge (see. Head Engine). At the M57 engine disconnect the left and right consoles from a cross-section beam of the forward bridge.
  1. Give a nut and disconnect cross-section steering draft from a soshka of a steering and from the left rotary fist a stripper No. 32 1 190.

At installation on a landing cone and an opening there should not be greasing traces. Replace самоконтрящуюся a nut.

  1. Disconnect the steering mechanism from a beam of the forward bridge.

At installation fix the steering mechanism on a beam of the forward bridge at first by hand a bolt (1), and then tighten consistently with demanded effort bolts (2) and (1). Use new самоконтрящиеся nuts.

  1. Remove thermofilters and elements of strengthening of a body with left and on the right side. Disconnect a cable from a conclusion of the positive plug of the storage battery. If necessary disconnect an oil pipeline from a beam of the forward bridge.
  1. Bring a jack with the adaptation No. 31 2 220 under a beam of the forward bridge and turn out bolts with left and on the right side.

At a detachment of fastening of a beam of the forward bridge from a body under the forward bridge nobody should be!


  1. Give the top nuts of fastening of racks of a suspension bracket with left and on the right side. At the corresponding complete set separate the EDC system socket. Uncover racks.

At installation use new nuts.

  1. Remove a suspension bracket assembled. In order to avoid damage of spherical support and loker watch the provision of racks, without allowing them to bend strongly. When lowering jack the certain person should support each rack.
  2. Installation is made upside-down.


«previous page
12.1. General information, recommendations and security measures
following page»
12.2.1. Removal and suspension bracket installation assembled









http://b3-b4.ru/