BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and suspension bracket installation assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross-section lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross-section stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

12-2-3-snyatie-i-ustanovka-levogo-ili-pravogo-poperechnogo-rychaga-podveski.html

12.2.3. Removal and installation of the left or right cross-section lever of a suspension bracket

 PERFORMANCE ORDER

  1. Remove a forward wheel.
  1. Disconnect the cross-section lever of a suspension bracket from a beam of the forward bridge and a rotary fist.

At installation from both parties establish a washer (1), use new самоконтрящиеся nuts.


  1. Turn out a bolt, establish the adaptation No. 31 2 200 in a cut and turn on a corner 90 °. Pull down a rotary fist.
  1. By means of a stripper No. 31 2 240 disconnect the cross-section lever of a suspension bracket from a rotary fist.

At installation on landing cones there should not be greasing traces.


  1. Installation is made upside-down. By means of a jack raise a rotary fist before combination of a bolt with an opening of a plate (1), – the bolt should enter into this opening. Remove the adaptation No. 31 2 200 and tighten bolts. Upon termination of works check corners of installation of forward wheels.


«previous page
12.2.2. Removal and installation of a beam of a suspension bracket
following page»
12.2.4. Removal and installation of extensions of levers and hinges of extensions