BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and suspension bracket installation assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross-section lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross-section stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes




0c1943ba

12-2-2-snyatie-i-ustanovka-balki-podveski.html

12.2.2. Removal and installation of a beam of a suspension bracket

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the storage battery.
  2. Establish the engine in assembly situation as it is described in the Section Removal and installation of the pallet of a case in Head the Engine.
  3. To remove from a beam of a forward suspension bracket the steering mechanism, without disconnecting the GUR line (see. The section Removal and installation of the steering mechanism with GUR).
  4. Remove protection of a case of the engine and to disconnect the left and right pillows of fastening of the engine from a cross-section beam of the forward bridge (see. Head Engine). At the M57 engine disconnect the left and right consoles from a cross-section beam of the forward bridge.
  1. Disconnect the left and right cross-section levers of a suspension bracket from a beam of the forward bridge.

At installation with left and on the right side establish washers (1), use new самоконтрящиеся nuts.


  1. Remove the pendular lever.

At installation use new самоконтрящуюся a nut.


  1. Remove thermofilters and elements of strengthening of a body with left and on the right side. Disconnect a cable from a conclusion of the positive plug of the storage battery. If necessary disconnect an oil pipeline from a beam of the forward bridge.
  1. Remove an extension of the lever of a suspension bracket.

At installation establish a washer (1) and use new самоконтрящуюся a nut.


  1. Disconnect the stabilizer of cross-section stability from its rack. Give a nut and disconnect cross-section steering draft from a soshka of a steering and from a rotary fist by means of a stripper No. 32 1 190.

At installation use new самоконтрящуюся a nut.


  1. Turn out bolts with left and on the right side and remove a beam of the forward bridge. Disconnect from a beam the stabilizer of cross-section stability.
  1. Installation is made upside-down. Upon termination of works check corners of installation of forward wheels. At installation of a new beam it is necessary to adjust a steering soshka.


«previous page
12.2.1. Removal and suspension bracket installation assembled
following page»
12.2.3. Removal and installation of the left or right cross-section lever of a suspension bracket