BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Replacement of brake shoes
11.3. Removal and installation of brake disks
11.4. Removal and installation of supports
11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism
11.6. Adjustment of the parking brake
11.7. Removal and installation of cables and pedal of a drive of the parking brake
11.8. Removal Д/В of stoplights and pedal of a working brake
11.9. Removal and GTTs installation and its tank
11.10. Removal and installation of the one-pass valve of the vacuum amplifier
11.11. Removal and installation of the vacuum amplifier
11.12. Removal and installation of wheel sensors
11.13. Removal and installation of the electronic control unit of ABS/ASC+T/DSC systems
11.14. Removal and installation hydromodulator of ABS/ASC+T/DSC systems
11.15. Removal and installation of sensors of cross-section acceleration of DSC3
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


11-8-snyatie-d-v-stop-signalov-i-pedali-rabochego-tormoza.html

11.8. Removal Д/В of stoplights and pedal of a working brake

Д/В stoplights

 PERFORMANCE ORDER

  1. Remove furnish of assembly of pedals.

Models to 09.1998 g вып.

 PERFORMANCE ORDER

  1. Separate the socket of electroconducting Д/В of stoplights.
  1. Squeeze out a brake pedal. If necessary use for this purpose a strut.
  1. Extend a pusher with the plug up to the end forward (1), compress clips (2) and remove the switch movement back.
  1. Installation is made upside-down. Slowly release a brake pedal in a starting position.

Models from 09.1998 g вып.

On all cars with DSC system between a pedal of a brake and Д/В stoplights the gap in 0.7 mm should be established. If at such gap faultless functioning is not provided, reduce a gap to 0.6 mm.


 PERFORMANCE ORDER

  1. Separate the socket (1), take out Д/В stoplights (2) of the holder (4) in the direction specified by an arrow.
  1. Squeeze out a pedal of a brake (3) and establish Д/В stoplights in the holder against the stop. Holding the holder, slowly return a brake pedal to a starting position and take away it back further away (against the stop).

Pedal

 PERFORMANCE ORDER

  1. Remove the left bottom section of furnish of the dashboard (see. Head Body).
  2. To remove Д/В stoplights.
  1. Remove lock brackets (1), take out a finger (2) and to remove a brake pedal.
  1. Installation is made upside-down. Check a condition of the axial plug of a pedal of the plug and if necessary replace it. Grease surfaces of sliding of the plug.



«previous page
11.7. Removal and installation of cables and pedal of a drive of the parking brake
following page»
11.9. Removal and GTTs installation and its tank









http://b3-b4.ru/