BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Replacement of brake shoes
11.3. Removal and installation of brake disks
11.4. Removal and installation of supports
11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism
11.6. Adjustment of the parking brake
11.7. Removal and installation of cables and pedal of a drive of the parking brake
11.8. Removal Д/В of stoplights and pedal of a working brake
11.9. Removal and GTTs installation and its tank
11.10. Removal and installation of the one-pass valve of the vacuum amplifier
11.11. Removal and installation of the vacuum amplifier
11.12. Removal and installation of wheel sensors
11.13. Removal and installation of the electronic control unit of ABS/ASC+T/DSC systems
11.14. Removal and installation hydromodulator of ABS/ASC+T/DSC systems
11.15. Removal and installation of sensors of cross-section acceleration of DSC3
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


11-5-zamena-tormoznykh-kolodok-stoyanochnogo-tormoza-i-ikh-razzhimnogo-mekhanizma.html

11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism

 PERFORMANCE ORDER

  1. Remove a brake disk of a back wheel (see. Section Removal and installation of brake disks).
  1. Unhook returnable springs from blocks. Check a condition of springs and if necessary replace them.
  1. Turn pins by means of the special adaptation No. 34 4 000 on a corner 90 ° and take out them. Remove brake shoes.
  1. In need of removal of the razzhimny mechanism remove a detail (A), having pulled it back. Vypressuyte a pin (B) also take out a detail (C).
Right wheel
  1. Installation is made upside-down. Be convinced of correctness of installation of the plug (1) and the adjusting screw (2), grease their carving. In summary adjust the parking brake (see. Section Adjustment of the parking brake).


«previous page
11.4. Removal and installation of supports
following page»
11.6. Adjustment of the parking brake









http://b3-b4.ru/