BMW 7_ая the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and operation receptions
3. Settings and routine maintenance of the car
4. Engine
5. Systems of cooling of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Kardanny and power shafts, reducer, differential and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Replacement of brake shoes
11.3. Removal and installation of brake disks
11.4. Removal and installation of supports
11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism
11.6. Adjustment of the parking brake
11.7. Removal and installation of cables and pedal of a drive of the parking brake
11.8. Removal Д/В of stoplights and pedal of a working brake
11.9. Removal and GTTs installation and its tank
11.10. Removal and installation of the one-pass valve of the vacuum amplifier
11.11. Removal and installation of the vacuum amplifier
11.12. Removal and installation of wheel sensors
11.13. Removal and installation of the electronic control unit of ABS/ASC+T/DSC systems
11.14. Removal and installation hydromodulator of ABS/ASC+T/DSC systems
11.15. Removal and installation of sensors of cross-section acceleration of DSC3
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Electric equipment schemes


11-3-snyatie-i-ustanovka-tormoznykh-diskov.html

11.3. Removal and installation of brake disks

To replace brake disks follows in pairs, i.e. on both wheels of one axis. Thus it is necessary to replace also brake shoes (see. Section Replacement of brake shoes).


 PERFORMANCE ORDER

  1. Remove wheels. If necessary remove and clear brake shoes (see. Section Replacement of brake shoes).
  2. Turn out bolts of fastening of a support and suspend it on a body, without disconnecting a brake hose.
Bolts (1) fastening of a support of the back brake mechanism
Bolts of fastening of a support of the forward brake mechanism

The brake hose should not test thus tension.


  1. Turn out a bolt and remove a brake disk.

For a reversing of bolts of fastening of a brake disk it is not allowed to beat a hammer or something similar on a frictional ring! If necessary carefully knock with a hammer with soft brisk on the basis of a brake disk.

  1. Carefully clear on a wheel nave the plane of interface to a brake disk, if necessary remove corrosion traces. Roughnesses on the interfaced plane can lead to a buckling of a brake disk.
  2. Ventilated brake disks отбалансированы by means of the balancing brackets established on internal diameter of a disk, – do not delete and do not move them.
  3. Measure thickness of a brake disk and if necessary replace it.
  4. Installation is made upside-down. On termination of works on the back brake mechanism adjust the parking brake (see. Section Adjustment of the parking brake).


«previous page
11.2. Replacement of brake shoes
following page»
11.4. Removal and installation of supports









http://b3-b4.ru/